After a long time running, jaw plates need an exchange. The following wear parts are required: A new fixed jaw plate A new movable jaw plate Never weld external lifting eyes to the jaw plates. Always use the referred lifting cavity on the jaw plate and the lifting tool provided with the jaw crusher. …
Maintenance for these parts must be carried out only by trained or authorized personnel, but the inspection can be performed by the operator. Worn components should be replaced in good time to avoid damaging the toggle plate or toggle seats, with a consequent need for expensive repairs. Sandvik recommends exchanging the toggle plate (5006-0) and…
To ensure optimum performance and cost-effective production it’s important to frequently inspect the following parts and to replace them before they are completely worn out. 3500-0 Deflector plate (moving jaw only) 3400-0 Clamping bar 3300-1 Jaw plate 3100-0 Wear plate 3200-0 Support bar Jaw plates The wear pattern and the adjustment of the jaw plates…
Jaw dies can either be turned end for end or replaced depending on their wear. The jaw dies can be turned once after their installation before they need to be replaced. Fixed Jaw Die Clean the jaw die lifting holes. Remove stones and sand from the jaws. Remove material packed between the jaw and side…
Jaw plates can either be turned end for end or replaced depending on their wear. The jaw dies can be turned once after their installation before they need to be replaced. Dismantling Fixed Jaw Plates Clean the jaw die lifting holes. Remove stones and sand from the jaws. Also, remove material packed between the jaw…
Protection plates are designed for additional protection of the crusher’s frame and pitman. They are recommended when using small settings (always greater than or equal to the minimum recommended setting) and/or when the rock to be crushed is very hard (i.e. very low crushability). Of course, these can be used at any time for added…
The intermediate plate is an important jaw crusher wear parts. Fitting an intermediate (backing) plate behind the fixed jaw die reduces the nip angle of the crusher. The intermediate plate reduces the feed opening and the setting range by approximately the same amount as its thickness. However, the intermediate plate does not, under normal circumstances,…
Different jaw plates tooth profiles suit for different working conditions. If you want to decrease your cost, you must choose the right tooth profiles. Qiming Machinery’s engineers will show you which tooth profiles suit for which conditions. Standard Tooth Recommended Usage: Suitable for both rock and gravel crushing. Wear life, power requirements and crushing stresses…
We have a customer from Australia, who runs MVP450 cone crusher to crush hard stone. However, the original wear parts just can work for around 7 days. This customer wants to prolong this mantle and concave span life. After visiting our foundry, this customer wants us to manufacture TIC insert MVP450 mantle and concave to…
Qiming Machinery is a professional cone crusher liner manufacture in China. We had exported more than 12,000 tons of cone crusher liners for our customers. Recently, we get a trail order from Serbia to test our Mn18Cr2 HP300 cone crusher mantle and concave. About the feedback, please check the following communication message: T The messages…
English
Arabic
Czech
Danish
Esperanto
Finnish
French
German
Indonesian
Italian
Kazakh
Mongolian
Portuguese
Russian
Spanish
Swedish
Ukrainian